Course Overview
This training course covers monitoring, managing and configuring your edge-to-core network with the HPE Intelligent Management Center software platform (HPE IMC). This course starts with a discussion of how HPE Intelligent Management Center is installed, how devices are added through discovery, and then how they can be viewed. The course also goes through configuration management, along with VLAN management and then explains how HPE Intelligent Management Center is used to manage both firmware and configuration on devices. We also discuss how alarms are received and processed in HPE Intelligent Management Center, along with trap management. Finally, we look at performance management and the Virtualization Resource Management (VRM) component against an ESXi host. The lab exercises are focused around Comware, Aruba Edge (AOS) and Aruba CX Switches, and some Cisco. This course is approximately 40 percent lecture and learning activities and 60 percent hands-on lab activities.
Who should attend
This course is intended for network or systems administrators, network engineers, and consultants who plan to deploy, manage, monitor, and configure HPE Intelligent Management Center
Prerequisites
Learners should have some networking experience to get the most from this training course. They should:
- Understand networking, along with IPv4 addressing
- Have some knowledge of the CLI commands on HPE Aruba Switches (AOS and CX), Comware v7 and Cisco (this knowledge is beneficial, but not required)
- Understand file architecture on Comware and Aruba, including Telnet/SSH, and start up and saved configurations
- Understand SNMP configuration
- Understand traps and how they are configured on the switches
Course Objectives
By the end of the course, you should be able to:
- Understand the HPE Intelligent Management Center installation process and how to initially access HPE Intelligent Management Center
- Understand how to add devices into HPE Intelligent Management Center using auto discovery
- Understand the different views in HPE Intelligent Management Center and how they can be utilized
- Understand the Configuration Centre and how it can be used for configuration management
- Understand how alarms and traps are generated in HPE Intelligent Management Center
- Understand how HPE Intelligent Management Center can be used to manage, monitor and configure VLANs.
- Understand how HPE Intelligent Management Center can be used for performance management
- Understand how HPE Intelligent Management Center can be used for virtualization resource management
- Understand how to troubleshoot HPE Intelligent Management Center
Course Content
- Module 1: HPE Intelligent Management Center Introduction
- Module 2: Installation and Initial Access
- Module 3: Adding Devices
- Module 4: Trap Management
- Module 5: View Management
- Module 6: Configuration Management
- Module 7: Alarms and Events
- Module 8: VLAN Management
- Module 9: Performance Management
- Module 10: Virtualization Management
- Module 11: Troubleshooting HPE Intelligent Management Center
Deutsch
Englisch